1.29 CAMSHAFT DRIVE GEAR 1.29.4 Installation of Camshaft Drive Gear Continue installing camshaft drive gear assembly as follows: 1. Coat the camshaft thrust plate O-ring with clean engine oil. 2. Install it into its groove in the camshaft thrust plate. 3. Install a new diamond seal in the camshaft thrust plate groove by pressing it in with the rounded end of the seal extractor or the flat end of a ruler. 4. Be sure the O-ring sealing surface of the gear case is clean and free of burrs. 5. Install the hub and camshaft thrust plate to the opening in the gear case.
The depression in the rear face of the camshaft thrust plate must be positioned at 12 o'clock, see Figure 1-443, to align the retaining bolts in the thrust plate with those in the head and No. 1 camshaft cap. 6. Using a fiber mallet or plastic hammer, tap the camshaft drive gear at 90 degree intervals toward the engine, until the thrust plate bolts can be started in the cylinder head and No. 1 camshaft cap. NOTICE: Make sure camshaft dowel hole in camshaft drive hub is aligned with camshaft dowel prior to tightening thrust plate bolts. A misaligned hub can cause damage to the camshaft and thrust plate components NOTICE:
Use care when installing the camshaft thrust plate retaining bolts to prevent accidentally dropping them into the gear case and causing damage to gear train. 7. Using a 13 mm socket and ratchet, tighten the thrust plate bolts alternately and evenly to draw the thrust plate straight into the gear case. Torque the bolts to 30 - 38 N·m (22-28 lb·ft). 8. Install the gear case cover. Refer to section 1.10.3. NOTICE: Always hold the camshaft drive gear stationary using camshaft drive gear retaining tool (J–35652–B) to prevent component damage, while loosening or tightening the camshaft drive gear-to-camshaft bolt. NOTE:
Before installing the fan support bracket and camshaft drive gear access cover, it will be necessary to install and tighten the camshaft drive gear retaining bolt, and to measure and adjust the adjustable gear-to-camshaft drive gear lash. (Rev. 2005) All information subject to change without notice. 1-500 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION