Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 2. Install the hub to the camshaft thrust plate. 3. Install the key into the keyway on the hub. 4. Apply a thin film of Lubriplate to the bore of the camshaft gear. 5. Support the hub from the engine side. NOTICE: A minimum force of 20 kN (4500 lb) must be obtained when pressing the gear on the hub which can distort camshaft gear if applied off center. Only apply force to the inner hub of the gear when pressing. 6. Align the keyway in the camshaft drive gear with the key in the hub and press the gear, onto the hub until it is firmly seated against the shoulder.

1.29.3.1 Testing of Camshaft Drive Gear Assembly Run-out Measure the camshaft drive gear assembly run-out as follows: 1. While supporting the camshaft thrust plate on blocks, position the camshaft drive gear assembly with the engine side facing down. 2. Assemble a dial indicator and magnetic base with the indicator stem resting on the face of the camshaft drive gear, just inboard of the drive gear teeth. Zero the dial indicator. 3. Rotate the drive gear two full rotations while reading the total indicated run-out. NOTE: The total amount the dial indicator needle moves to the left and right of zero, added together, gives the total indicated run-out Total Indicator Reading (TIR).

[a] If the measured value is 0.114 mm (0.0045 in.) or less, then the drive gear assembly can be reused. [b] If the measured value is more than 0.114 mm (0.0045 in.), the drive gear assembly parts must be replaced. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-499