Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.30 ADJUSTABLE IDLER GEAR ASSEMBLY The adjustable idler gear bushing has a series of machined grooves in the contact surface, for oil retention. The bushing is not serviced separately. If the bushing becomes worn or damaged, the gear and bushing must be replaced as an assembly. There are three bolt holes in the hub where it is inserted over the studs. See Figure 1-452. Figure 1-452 Adjustable Idler Gear Bolt Hole Location The top two holes are elongated, to allow the idler gear and hub assembly to be moved in relationship to the camshaft drive gear. The bottom stud hole is not elongated, and is a close fit to the stud.

This allows the adjustable idler gear to pivot on the bottom stud, so the adjustable idler gear to camshaft drive gear lash can be adjusted without changing the clearance between the adjustable idler gear and camshaft idler gear. The adjustable idler gear retaining plate has a flat on the bottom to clear the bull gear for removal and installation. See Figure 1-453. Figure 1-453 Adjustable Idler Gear Retaining Plate (Rev. 2005) All information subject to change without notice. 1-504 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION