Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 1.30.2.1 Inspection of Adjustable Idler Gear Assembly Inspect the adjustable idler gear assembly as follows: 1. Wash the adjustable idler gear, hub, and retaining plate thoroughly in clean fuel oil. EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 2. Dry with compressed air. 3. Examine the gear teeth for evidence of scoring, pitting and wear. NOTE: If gear teeth are damaged, also inspect the other gears in the gear train. [a] If severely damaged or worn, replace the gear. [b] If no damage is found, reuse the gear. 4.

Inspect the contact surface of the hub for scoring or evidence of overheating (blue discoloration). [a] If hub has blue discoloration, replace the hub. [b] If hub has no blue discoloration, reuse the hub. [c] If slight irregularities are present, use a fine stone or emery cloth to remove them. 5. Check the lubrication hole and gallery in the gear case for blockage. [a] If the lubrication hole is blocked, clear the lubrication hole. [b] If the lubrication hole is not clogged, no cleaning is required. 6. Inspect the bushing contact surface of gear and bushing assembly for signs of scoring, discoloration due to overheating, or excessive wear.

[a] If the surface of the bushing is not acceptable, replace the gear and bushing as an assembly. [b] If the surface has no damage, reuse the bushing assembly. 7. Measure the clearance between the bushing and hub. [a] If the clearance is more than 0.033 - 0.076 mm (0.0013 -0.0030 in.), replace the gear and bushing as an assembly. [b] If the clearance is to specification, 0.033 - 0.076 mm (0.0013 -0.0030 in.), reuse the gear and bushing assembly. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-509