Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.30 ADJUSTABLE IDLER GEAR ASSEMBLY NOTICE: Always use crankshaft protector (J–35994) to guard against damage to the oil seal area of the crankshaft. When removing the bull gear or camshaft idler gear and hub assembly, do not come in contact with the oil seal contact surface of the crankshaft. If sealing surface is scratched, an oil leak may result. 6. Install J–35994 to the oil seal contact area of the crankshaft. 7. Working through the four access holes in the bull gear and camshaft idler assembly, remove two of the four bolts that secure the bull gear and camshaft idler gear hub to the cylinder block. See Figure 1-457. Figure 1-457 Removing Bull Gear and Camshaft Idler Gear Hub 8.

Install J–35785 to the holes from where the bolts were removed. 9. Remove the remaining two bull gear and camshaft idler gear hub bolts. 10. Grasp the bull gear and remove the bull gear and camshaft idler gear and hub assembly from its recess in the cylinder block. 11. Remove the three adjustable idler gear flanged locknuts. 12. Remove the adjustable idler gear hub retaining plate. 13. Remove the adjustable idler gear and hub. (Rev. 2005) All information subject to change without notice. 1-508 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION