Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 4. Install thrust plate with the relief at the bottom. See Figure 1-457. 5. Install the three flanged locknuts, finger-tighten. 6. Install J–35785 and (J–35994) to the cylinder block. 7. Coat the bearings and contact surfaces of the bull gear assembly with clean engine oil. 8. Looking through the inspection hole in the bull gear, align the timing marks on the camshaft idler gear (mounted to the rear of the bull gear) with the adjustable idler gear. Align the timing marks on the bull gear and crankshaft timing gear. Refer to section 1.24.2.1. Install the bull gear hub assembly to the cylinder block. See Figure 1-458. 9.

Install the bull gear hub assembly to the cylinder block. Refer to section 1.33.3. 10. Install the gear case cover. Refer to section 1.10.3. 11. Adjust the gear lash between the adjustable idler gear and camshaft drive gear. Refer to section 1.24.2.1. 12. Install any other components that were removed for access to the gear case cover. 13. Refer to section 12.7 for verification of proper adjustable idler gear assembly installation. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-511