SERIES 60 SERVICE MANUAL The adjustable idler gear bushing has a series of machined grooves in the contact surface, for oil retention. The bushing is not serviced separately. If the bushing becomes worn or damaged, the gear and bushing must be replaced as an assembly. There are three bolt holes in the idler hub, and a hub locating dowel which is drilled to supply oil to the bushing from a drilling in the block. All holes are oversize, to allow the idler gear and idler hub assembly to be moved in relationship to the camshaft drive gear.
This allows the adjustable idler hub to pivot on the locating dowel, so the adjustable idler gear to camshaft drive gear lash can be adjusted without changing the clearance between the adjustable idler gear and camshaft idler gear. The adjustable idler gear retaining plate has a flat on the bottom to clear the bull gear for removal and installation 1.31.1 Repair or Replacement of Adjustable Idler Gear Assembly To determine if repair or replacement of the adjustable idler gear assembly is necessary, perform the following procedure. See Figure 1-460. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-513