SERIES 60 SERVICE MANUAL 2. Install the idler hub, with the Part Number facing outward, to the studs in the gear case with the locating pin in the idler hub towards the gear case. See Figure 1-462. 1. Gear Case 3. Stud Bolt 2. Idler Hub 4. Stud Figure 1-462 Idler Hub and Related Parts 3. Install the adjustable idler gear with the Part Number facing outward, and install adjustable idler gear hub retaining plate. 4. Install three nuts onto stud bolts and finger tighten. 5. Install the bull gear and camshaft idler gear assembly Refer to section 1.32.3. 6. Install the gear case cover. Refer to section 1.11.3. 7. Install the camshaft gear assembly. Refer to section 1.26.5. 8.
Adjust the gear lash between the adjustable idler gear and camshaft drive gear. Refer to section1.25.2.2. 9. Torque three idler gear nuts previously installed to 103-113 N·m (76-83 lb·ft). 10. Install any other components that were removed for access to the gear case cover. 11. Refer to section 12for verification of proper camshaft drive gear installation. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-517