SERIES 60 SERVICE MANUAL The bull gear and camshaft idler gear are installed on a spindle, the spindle is bolted to the engine block. The camshaft must be in time with the crankshaft timing gear. Timing marks have been stamped or etched on the face of the bull gear and crankshaft timing gear to facilitate correct gear train timing. See Figure 1-464. 1. Crankshaft Timing Gear 3. Timing Marks 2. Bull Gear Figure 1-464 Compact Gear Train and Engine Timing Marks The backlash between the various mating gears in the gear train should be 0.051-0.229 mm (0.002 -0.009 in.), and should not exceed 0.305 mm (0.012 in.) backlash between worn gears. NOTE:
All gear lash measurements should be taken with engine in an upright position. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-519