SERIES 60 SERVICE MANUAL NOTICE: Use care when removing the bull gear and camshaft idler gear assembly from the engine so that it does not come in contact with the oil seal contact surface of the crankshaft. If this sealing surface is scratched, an oil leak may result. 3. Working through the four access holes in the bull gear carrier, loosen and remove two of the four bolts that secure the bull gear assembly to the cylinder block. See Figure 1-475. Figure 1-475 Removing Bull Gear Assembly Retaining Bolts 4. Install J–35785 into the holes the bolts from where they were removed. 5. Remove the two remaining bull gear retaining bolts. 6.
Grasp the bull gear and pull the assembly straight out of the recess in the cylinder block. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-531