Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.33 BULL GEAR AND CAMSHAFT IDLER GEAR ASSEMBLY 1. Check the SRS pin for damage or looseness. If the SRS pin is damaged or dislodged, replace the pin as follows: [a] Press the SRS pin from the bull gear. Discard pin. NOTICE: Do NOT reuse or readjust a pin once it has been installed. Damage to pin will cause loss of engine performance. [b] Apply Loctite 609 (PT 7260) to pin. [c] Press pin flush to 0.25 mm (0.010 in.) below bull gear surface. [d] If no damage is found, reuse the bull gear assembly. 2. Using straight edge and thickness gages, measure recess of SRS pin. [a] If pin is not flush to 0.25 mm (0.010 in.) below bull gear surface, replace the pin.

[b] If the pin is to specifications 0.25 mm (0.010 in.), reuse the part. (Rev. 2005) All information subject to change without notice. 1-534 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION