Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 1.33.3 Installation of Bull Gear and Camshaft Idler Gear Assembly Install bull gear assembly and camshaft assembly as follows: 1. Inspect the bull gear and camshaft idler gear access opening in the gear case and remove any foreign material. Be sure the lubrication oil holes are clear and free. 2. Install two Bull Gear Guide Studs (J–35785) to the cylinder block. See Figure 1-477. Figure 1-477 Bull Gear Guide Stud Installation 3. Install J–35994 to the oil seal contact area of the crankshaft. NOTE: The crankshaft seal surface will be protected using J–35994, when installing the bull gear and camshaft idler gear assembly to the cylinder block. 4.

Install the bull gear and camshaft idler gear assembly to the guide studs in the cylinder block. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-535