1.34 CRANKSHAFT TIMING GEAR AND TIMING WHEEL 12. Remove the special tools as follows: [a] Open the valve on the hydraulic pump. [b] Remove J–35642–3 (part of tool set J–35642) from the end of the base post threaded rod. [c] Remove the hydraulic ram from the base post rod. [d] Remove the three retaining nuts from the puller legs of J–35642–2 (part of tool set J–35642). [e] Remove J–35642–4 (part of tool set J–35642) from the three pulley legs. [f] Remove the three legs of J–35642–2 (part of tool set J–35642) from the threaded holes in the crankshaft timing gear. [g] Remove J–35642–1 (part of tool set J–35642) and two crankshaft pulley retaining bolts from the end of the crankshaft. 13.
Install the bull gear and camshaft idler gear assembly to the gear case. Refer to section 1.33.3. NOTE: Be sure to time the gears as instructed. 14. Install the lubricating oil pump, inlet and outlet pipes. Refer to section 3.2.6. 15. Measure the gear lash between the crankshaft timing gear and oil pump drive gear. Refer to section 1.24.2.1. 16. Measure the lash between the crankshaft timing gear and the bull gear. Refer to section 1.24.2.1. 17. Install the gear case cover. Refer to section 1.10.3. 18. Install a new crankshaft seal and sleeve. Refer to section 1.8.5. 19. Install the Timing Reference Sensor (TRS). Refer to section 2.32.3. 20.
Install any components that were removed for access to the gear case cover. 21. Refer to section 12.3 for verification of proper crankshaft timing gear and timing wheel installation. (Rev. 2005) All information subject to change without notice. 1-556 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION