SERIES 60 SERVICE MANUAL 1. Attach the accessory drive gear to the holding fixture (J–36024–3, part of toolset J–36024–C) using the three bolts provided. See Figure 1-501. Figure 1-501 Holding Fixture 2. Place the accessory drive assembly holding fixture into a vise. See Figure 1-502. Figure 1-502 Accessory Drive Pulley Locknut Removal 3. Remove the accessory drive pulley locknut. See Figure 1-502. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-563