Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.35 ACCESSORY DRIVE 4. Remove the accessory drive pulley by tapping it with a rubber hammer or fiber mallet. If the pulley does not come off easily, use a puller to remove it. 1. Seal Sleeve Figure 1-503 Accessory Drive Seal Remover (J–45533) NOTE: Perform steps 5, 6 and 7 unitized seal removal procedure for accessory drive assemblies on engines built after December 2000. 5. Using J–45533 remove seal sleeve. [a] Ensure taper end of puller bolt is pointed toward inside jaws. [b] Place inside jaws of tool over sleeve. See Figure 1-503. [c] Finger tighten hex bolt on side of tool. [d] Remove sleeve by tightening puller bolt. (Rev. 2005) All information subject to change without notice.

1-564 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION