Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 6. Removal of seal. [a] Invert puller bolt. See Figure 1-504. Figure 1-504 Accessory Drive Seal Remover (J–45533) [b] Loosen hex bolt on side of tool. [c] Using a rubber mallet, gently drive outside jaws between seal and shaft through the rubber membrane of seal until tool bottoms out. [d] Finger tighten hex bolt on side of tool. [e] Remove seal by tightening puller bolt. 7. Clean accessory drive housing at seal location. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-565