Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.35 ACCESSORY DRIVE 8. Position the accessory drive assembly on a press bed with the holding fixture supported. See Figure 1-505. Figure 1-505 Accessory Drive Gear Removal 9. Using a press, apply pressure through the access hole in the holding fixture (J–36024–3, part of toolset J–36024–C) and press the drive shaft out of the gear. See Figure 1-505. 10. Remove the snap ring from the accessory drive housing. See Figure 1-506. Figure 1-506 Snap Ring Removal (Rev. 2005) All information subject to change without notice. 1-566 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION