SERIES 60 SERVICE MANUAL 11. Turn the housing over and support the accessory drive housing on the machined surface using V-blocks. 12. Using a press, apply pressure to the pulley end of the shaft and remove the shaft and bearing assembly. 13. Turn the accessory drive housing over, and support it on the attaching bolt bosses using V-blocks. NOTE: On current design, the shaft serves as the inner race for the needle bearing. NOTICE: For assemblies with inner race for needle bearing, place the accessory drive shaft in a vise with soft jaws taking care not to damage the shaft surface. 14. Install J–36024–9 (part of toolset J–36024–C) and apply pressure to remove the needle bearing.
See Figure 1-507. Figure 1-507 Needle Bearing Removal All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-567