Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 17. Position two steel press plates under the ball bearing outer race. See Figure 1-510. Figure 1-510 Position of the Steel Press Plates NOTE: Whenever the needle or ball bearing is removed from the shaft, they MUST be replaced with new bearing assemblies. 18. Use a press to apply pressure to the top of the shaft and remove the ball bearing from the shaft. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-569