Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.35 ACCESSORY DRIVE 1.35.3.1 Inspection of the Accessory Drive Clean the accessory drive prior to inspection as follows: 1. Clean all of the parts with clean fuel oil. EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 2. Dry parts with compressed air. To inspect the accessory drive visually examine the drive shaft for damage check the drive shaft for galling, pitting, cracks, or other damage. If any damage is detected, replace with a new part. If no damage is found, reuse the part. 1.35.4 Assembly of the Accessory Drive Assemble the accessory drive as follows:

(Rev. 2005) All information subject to change without notice. 1-570 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION