Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 3. Place the needle bearing inner race on the accessory drive shaft. Use tool J–36024–8 (part of toolset J–36024–C) and a press to install the bearing inner race to the shaft until it is tight against the shoulder. See Figure 1-513. NOTE: On current design accessory drive shaft, the needle bearing inner race is incorporated into the shaft. Figure 1-513 Needle Bearing Inner Race Installation All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-573