1.35 ACCESSORY DRIVE 4. Install the needle bearing to the accessory drive housing using tool J–36024–9 (part of toolset J–36024–C). See Figure 1-514. Figure 1-514 Needle Bearing Installation NOTE: The end of the bearing with the identification numbers must be against the installer. NOTE: The word INSTALL and an arrow are etched into the tool, J–36024–9 (part of toolset J–36024–C), to facilitate correct bearing installation. (Rev. 2005) All information subject to change without notice. 1-574 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION