SERIES 60 SERVICE MANUAL 5. Lubricate the oil seal contact area of the accessory drive housing with a thin film of engine oil. 6. Install the accessory drive oil seal to the accessory drive housing using the seal installer (J–36024–10, part of toolset J–36024–C) and a plastic hammer or fiber mallet. The oil seal must be installed flush to 0.25 mm (0.010 in.) below the face of the housing. See Figure 1-515. Figure 1-515 Accessory Drive Oil Seal Installation 7. Lubricate the oil seal with a thin film of engine oil. 8. Support the holding fixture (J–36024–3, part of toolset J–36024–C) on two steel plates and position the accessory drive housing into the hole in the fixture. See Figure 1-506.
All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-575