SERIES 60 SERVICE MANUAL 1.36 JAKE BRAKE The engine brake has been designed to fit on the Series 60 engine with no additional valve cover spacers. There are three styles of valve covers for the Series 60 engine. On engines equipped with a two-piece aluminum valve cover, it is NOT necessary to remove the lower valve cover to install the engine brake. However, one style of upper valve cover may require modification at the breather housing location (inside) for engine brake clearance. The model, part number and serial number are located on the nameplates at the top of each housing. See Figure 1-526. 1. Identification Plate Figure 1-526 Nameplate Location on Housing NOTICE:
Only the specific brake model can be used with the engine model it was designed for. Also, the correct slave piston adjustment specification must be used. Failure to follow these instructions may result in serious engine or engine brake damage. Listed in Table 1-9 are the different Jake Brake models used and the slave piston adjustment specification. All information subject to change without notice. (Rev.
2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-585 Model Number Model Year Engine Displacement Engine Brake Slave Piston Adjustment 6067WU40 Pre-1991 11.1L 760/760A 0.660 mm (0.026 in.) 6067GU40 Pre-1991 12.7L 760/760A 0.508 mm (0.020 in.) 6067WU60 1991 11.1L 760/760A 0.660 mm (0.026 in.) 6067GU40 1991 12.7L 765 0.660 mm (0.026 in.) 6067GU28 1991 12.7L 765 0.660 mm (0.026 in.) 6067GU91 1991 12.7L 765 0.660 mm (0.026 in.)