1.35 ACCESSORY DRIVE 1.35.5 Installation of the Accessory Drive Install the accessory drive as follows: 1. Install the O-ring seal in the groove on the drive housing. 2. Lubricate the O-ring with petroleum jelly. 3. Install the accessory drive housing to its original position in the gear case cover. NOTE: The word "UP" is cast into the drive housing. 4. Install the bolts that secure the accessory drive housing to the gear case cover and torque to 30-38 N·m (22-28 lb·ft) using the pattern shown. See Figure 1-525. Figure 1-525 Accessory Drive Housing Bolt Torque Sequence 5. Check the bull gear-to-accessory drive gear backlash. Refer to section 1.24.2.1. 6. Adjust the alternator belts.
Refer to section 14.6.9. 7. Tighten the alternator mounting bolts. 8. Install any other components removed for this procedure. 9. Refer to section 12.3 for verification of proper accessory drive installation. (Rev. 2005) All information subject to change without notice. 1-584 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION