SERIES 60 SERVICE MANUAL 1.36.2 Removal of Model 760, 765, or 770 Jake Brake Remove the model 760, 765, or 770 Jake Brake as follows: NOTE: The following procedures apply to Model 760, 765, and 777 Jake Brake. For Model 790/795 Jake Brake removal procedures, refer to section 1.36.6. PERSONAL INJURY To avoid injury, never remove any engine component while the engine is running. 1. Disconnect starting power for engine. Refer to OEM guidelines. 2. Remove the engine rocker cover. Refer to section 1.6.2for one-piece, refer to section 1.6.3 for two-piece and refer to section 1.6.5 for three-piece. NOTE:
If the engine is equipped with an aluminum two-piece valve cover, remove only the upper valve cover when installing the engine brake. 3. Note the location of the rocker arm shaft, the exhaust valve rocker arm, the fuel injector rocker arm, and the intake valve rocker arm. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-593