Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.36 JAKE BRAKE 4. Disconnect the solenoid wiring harness connectors from the engine brake solenoids. See Figure 1-531. 1. Cylinder Head 4. Washers (3 each) 2. Jake Brake Assembly 5. Capscrews (3 each) 3. Solenoid 6. Engine Brake Harness Figure 1-531 Jake Brake Assembly 5. Remove the nine capscrews and washers that secure the engine brake assemblies to the cylinder head. See Figure 1-531. NOTE: Only the Model 760 Jake Brake uses two different length capscrews. Six bolts, 120 mm (4.72 in.) long, are used on the exhaust side of the engine. Three bolts, 110 mm (4.33 in.) long, are used on the intake side of the engine. These bolts must be reinstalled in their correct positions. (Rev.

2005) All information subject to change without notice. 1-594 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION