SERIES 60 SERVICE MANUAL 7. Check the adjustment, and repeat if necessary. NOTE: Do not disassemble the slave piston adjusting screws. 8. Place the correct feeler gage between the leveling screw and the rocker arm adjusting screw. 9. Turn the leveling screw clockwise until a slight drag is felt on the feeler gage. See Figure 1-558. 1. Feeler Gage 3. Rocker Arm Adjusting Screw 2. Slave Piston Leveling Screw Figure 1-558 Setting Clearance on Leveling Screw and Rocker Arm Adjusting Screw 10. Hold the leveling screw in position, and torque the locknut to 47 N·m (35 lb·ft). 11. Check adjustment, and repeat if necessary. 12. Repeat the adjustment procedures for the remaining cylinders.
Refer to step 2 through step 11. NOTE: Bar over the engine when necessary to place the exhaust valves in the closed position for slave piston adjustment. 13. Install the engine rocker cover. Refer to section 1.6.8for one-piece, refer to section 1.6.9 for two-piece and three-piece. 14. Install all remaining components that were removed for this procedure. 15. Connect starting power for the engine. 16. Verify proper Jake Brake installation by driving the vehicle, then checking engine brake performance. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-621