Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.36 JAKE BRAKE 1.36.6 Removal of Model 790/795 Jake Brake Assembly Remove the Model 790/795 Jake Brake as follows: PERSONAL INJURY To avoid injury from hot surfaces, wear protective gloves, or allow engine to cool before removing any component. PERSONAL INJURY To avoid injury from accidental engine startup while servicing the engine, disconnect/disable the starting system. 1.

With the engine at ambient temperature and power to the starting system disconnected; refer to section 1.6.2 for a one piece rocker cover, refer to section 1.6.3 for a two piece rocker cover for diesel, refer to section1.6.4 for a two piece rocker cover for gas, refer to section 1.6.5 for a three piece rocker cover, and remove the engine rocker cover. NOTE: If the engine has a two-piece cover, the lower valve cover base does not have to be removed to gain access to the engine brake housings. 2. Note the location of the rocker arm shaft, the exhaust valve rocker arm, the fuel injector rocker arm, and the intake valve rocker arm. (Rev. 2005) All information subject to change without notice.

1-622 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION