Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. EYE INJURY 2. Dry components with compressed air. 3. Coat all (new and reuse) components to be installed into the housings with clean engine lube oil. 1.36.6.3 Inspection of Model 790/795 Jake Brake The Jacobs engine brake is typically a trouble-free device. However, inspections are necessary and some maintenance is required. Use the following procedures to keep the engine brake in top condition. Inspect the Jake Brake as follows: 1. Inspect the master piston bore for wear or damage. NOTE:

Some wear marks are permissible. [a] If worn or damaged, replace the master piston. [b] If not worn or damaged, continue with inspection. 2. Inspect the master piston and push rod for wear or damage. NOTE: Some wear marks are permissible. [a] If worn or damaged, replace the master piston or push rod. [b] If not worn or damaged, continue with inspection. 3. Apply clean lube oil to the piston, and insert into bore. NOTE: Master piston should move in and out freely with no binding. [a] If binding occurs, replace master piston and/or housing. [b] If no binding occurs, continue with inspection. 4. Inspect slave piston components for excessive wear or damage.

[a] If worn or damaged, replace slave piston component. [b] If not worn or damaged, proceed with inspection. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-627