1.36 JAKE BRAKE 5. Inspect the control valve bore for wear or damage. NOTE: Some wear marks are permissible. [a] If worn or damaged, replace the housing. [b] If not worn or damaged, continue with inspection. 6. Inspect adjusting screw for excessive wear or damage. [a] If worn or damaged, replace adjusting screw. [b] If not worn or damaged, proceed with inspection. NOTE: Model 790 Jake Brake uses a J-Lash assembly. Model 795 Jake Brake uses a solid screw. 7. Inspect capscrews for excessive wear or damage. [a] If worn or damaged, replace capscrews. [b] If not worn or damaged, proceed with inspection. 8. Inspect spacer tubes for excessive wear or damage.
[a] If worn or damaged, replace spacer tubes. [b] If not worn or damaged, proceed with inspection. 9. Inspect locknuts for excessive wear or damage. [a] If worn or damaged, replace locknuts. [b] If not worn or damaged, proceed with inspection. 10. Inspect solenoid for excessive wear or damage. [a] If worn or damaged, replace solenoid. [b] If not worn or damaged, proceed with inspection. 11. Inspect solenoid bore for excessive wear or damage. [a] If worn or damaged, replace solenoid. [b] If not worn or damaged, proceed with inspection. 12. Inspect slave piston bore for burrs at the depth where the slave piston contacts the adjusting screw. [a] If no burrs are found, proceed with inspection.
[b] If burrs are found, repair as follows: NOTE: The burr on the slave piston bore will not affect the performance of the brake. It only affects the ability to reset the lash. (Rev. 2005) All information subject to change without notice. 1-628 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION