SHOP NOTES Shop notes contains information on checking bearing clearances, the crankshaft remanufacturing procedures and a glossary. Cylinder Block Liner Boring Further information will be printed as it is developed. Checking Bearing Clearance A strip of soft plastic squeezed between the crankshaft journal and the connecting rod bearing or main bearing may be used to measure the bearing clearances. The strip is a specially molded plastic wire manufactured commercially and is available in three sizes and colors. Type PG-1 (green) has a clearance range of 0.0254-0.0762 mm (0.001 -0.003 in.). Type PR-1 (red) has a range of 0.0508-0.1524 mm (0.002 -0.006 in.).
Type PB-1 (blue) has a range of 0.1016-0.2286 mm (0.004 -0.009 in.). The plastic strip may be used for checking the bearing clearances as follows: 1. Remove the bearing cap and wipe the oil from the bearing shell and the crankshaft journal to be checked. NOTE: Check the main bearing clearances with the weight of the crankshaft supported by a jack under the counterweight adjoining the bearing being checked. If the engine is positioned with the main bearing caps supporting the crankshaft and flywheel, an erroneous reading could result. 2. Place a piece of plastic strip the full width of the bearing shell, about 1/4 inch off center. See Figure 1-568.
Figure 1-568 Using Plastic Strip to Measure Bearing-to-Crankshaft Clearance (Rev. 2005) All information subject to change without notice. 1-640 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION