Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 3. Install the bearing cap. Torque the bolts to 470-530 N·m (347-391 lb·ft). 4. Remove the bearing cap. The flattened plastic strip will be found adhering to either the bearing shell or the crankshaft. 5. Compare the width of the flattened plastic strip at its widest point with the graduations on the envelope. See Figure 1-568. The value within the graduation on the envelope indicates the bearing clearance in thousands of an inch. To obtain metric specifications: [a] Multiply the reading obtained (in thousandths) by 25.4. Taper may be indicated when one end of the flattened plastic strip is wider than the other. [b] Measure each end of the plastic strip.

The difference between the two readings is the approximate amount of taper. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-641