Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

CRANKSHAFT REMANUFACTURING PROCEDURES This section describes the procedures used to remanufacture crankshafts. Crankshaft Grinding In addition to the standard size main and connecting rod bearings, 0.254 mm, 0.508 mm and 0.762 mm (approximately 0.010 in., 0.020 in., and 0.030 in.), underseas bearings listed in Table 1-10 are available. Crankshafts which exhibit surface irregularities may be reground to utilize these bearings. Listed in Table 1-10, are guidelines to determine if the crankshaft is suitable for regrinding: * Dimension of reground crankshaft. Table 1-10 Crankshaft Journal Specifications Inspection Perform the following steps for part inspection: 1.

Determine if the crankshaft is from an 11.1 liter engine or a 12.7 liter engine. Listed in Table 1-11 are the forging number history for Series 60 crankshafts. Table 1-11 Crankshaft Part Number History 2. Inspect connecting rod and main bearing journals for discoloration due to excessive overheating from bearing failure. NOTE: Crankshafts with discoloration are not acceptable for rework. (Rev. 2005) All information subject to change without notice. 1-642 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION Bearing Size 11 & 12L Connecting Rod Journal Diameter 14L Connecting Rod Journal Diameter Main Bearing Journal Diameter Standard 85.000 - 84.975 mm (3.346 in.

- 3.345 in.) 95.000 - 94.975 mm (3.740 in. - 3.739 in.) 125.000 - 124.975 mm (4.921 in. - 4.920 in.) 0.254 mm (0.010 in.) Undersize *84.750 - 84.775 mm (3.336 in. - 3.337 in.) 94.750 - 94.775 mm (3.730 in. - 3.731 in.) *124.750 - 124.725 mm (4.911 in. - 4.910 in.) 0.508 mm (0.020 in.) Undersize *84.500 - 84.475 mm (3.327 in. - 3.326 in.) 94.500 - 94.475 mm (3.720 in. - 3.719 in.) *124.500 - 124.475 mm (4.902 in. - 4.901 in.) 0.762 mm (0.030 in.) Undersize *84.250 - 84.225 mm (3.317 in. - 3.316 in.) 94.250 - 94.225 mm (3.711 in. - 3.709 in.) *124.250 - 124.225 mm (4.892 in.

- 4.891 in.) Model Series 60 Crankshaft Forging Part Number Part Number History Year Released Fillet Finishing 11.1 Liter 8929238 1986 Induction Hardened 12.7 Liter 8929239 1986 Induction Hardened 14 Liter 23522887 1998 Induction Hardened