Table 1-14 Series 60 Crankshaft Remanufacturing Tolerances 12. Journal O.D. score marks must be: [a] Circumferential-not axial. [b] Maximum of 0.254 mm (0.010 in.) wide. [c] At least 3.175 mm (0.125 in.) from fillet tangent point. [d] Smooth, no proud metal. [e] Maximum of one mark per journal. 13. No journal dimpling permitted for removal of defects. 14. Nicks, dents or pits in journal O.D. must be 3.175 mm (0.125 in.) maximum diameter, no proud metal, maximum (3) per journal. 15. Pins and bearing journals which exhibit discoloration due to excessive overheating from bearing failure are not acceptable for rework. 16.
If one or more main or connecting rod journals require grinding, then grind all of the main journals or all of the connecting rod journals to the same required size. 17. Inspect the hardness of all journals. Crankshafts to be 47-55 Rc. (Rev. 2005) All information subject to change without notice. 1-648 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION Crankshaft Specifications Minimum Maximum Tolerance Pin Width 55.77 mm (2.196 in.) 56.07 mm (2.208 in.) 0.30 mm (0.012 in.) Timing Gear Diameter (must maintain 0.003 -0.005 in. press fit) 133.67 (5.263 in.) 133.70 mm (5.264 in.) 0.030 mm (0.0012 in.)