SERIES 60 SERVICE MANUAL 18. Clean the crankshaft as follows: [a] Clean all oil passages with a brush. Power probing is recommended. [b] Remove all copper, brass and lead, etc., from journal surfaces. Scrub the crankshaft until clean in a detergent bath. [c] Extremely rusted shafts can be soaked in hot rust stripper. [d] Scrub all webs and counterweights with a wire brush to remove all blackened residue. Use industrial detergent at proper ratios or regular hot degreaser. NOTICE: A crack in any vital area of the crankshaft cannot be repaired or removed. That is why magnetic particle inspection of the entire crankshaft before regrinding is mandatory.
Crankshafts that are cracked MUST BE SCRAPPED. 19. After a visual inspection, the crankshaft should be magnetically inspected using one of the two following methods: [a] Magnetic Particle Method: Refer to section 1.7.2.6. [b] Fluorescent Magnetic Particle Method: Refer to section 1.7.2.8. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-649