MACHINING OPERATIONS The following topics cover machining operations: Main and Connecting Rod Journals Main and Connecting Rod Journals: 1. Connecting rod and main bearing journal grinding should be performed with crankshaft rotation opposite to actual engine rotation. See Figure 1-571. NOTE: Crankshaft and main journal grinding should be performed with crankshaft rotation opposite to actual engine rotation. While polishing should be performed with the crankshaft rotation in the same direction as engine rotation. Figure 1-571 Crankshaft Grinding Rotation 2. Crankshaft polishing should be performed with the crankshaft rotation in the same direction as engine rotation. 3.
All connecting rod journal fillets must have a 5.75 mm (0.226 in.) radius between the crank cheek and the journal. 4. All connecting rod journal fillets must have a 5.75 mm (0.226 in.) radius between the crank cheek and the journal. All main journal fillets must have a 3.75 mm (0.148 in.) radius between the crank cheek and the journal. 5. No journal may have any sharp grind marks. The fillet must blend smoothly into the journal and the crank cheek and must be free of scratches. (Rev. 2005) All information subject to change without notice. 1-650 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION