1. 8922327 1/4 in. Pipe Plug (4 places). Torque to 19-24 N·m (14 -18 lb·ft). 6. 8929163 Dowel (Diamond) * § 2. 8929015 Dowel (Round) * 7. 5139991 Cup Plug (5 places) 3. 8929594 3/8 in. Pipe Plug (2 places). Torque to 24-31 N·m (18-23 lb·ft). 8. 8929152 Dowel (Round) * 4. 8924140 Draincock 9. 8922327 1/4 in. Pipe Plug (1 place). Opposite Oil Level Dipstick Location. 5. 8929022 Dowel (Diamond) (2 places)* ‡ § 10. 8929594 3/8 in. Pipe Plug (2 places). Torque to 24-31 N·m (18-23 lb·ft). *Installed to a height of 12.0 mm ± 0.5 mm (0.472 in. ± 0.002 in.). Use tool (J–36244–1)to install. Use tool (J–36224–2) to install. § Refer to illustration for orientation of dowels.
Cup plug 7 are installed 2.5-3.0 mm (0.098 in. -0.118 in.) below the machined surface. Use tool set (J–35653) to install the cup plugs. Coat the outside sealing edge of the cup plugs with a good grade of non-hardening sealant such as Loctite® 620 (or equivalent) before installing. Figure 1-578 Right Side View (Rev. 2005) All information subject to change without notice. 1-660 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION