Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

Pre-1991 Engines See Figure 1-584; see Figure 1-585; see Figure 1-586; see Figure 1-587; see Figure 1-588; see Figure 1-589; see Figure 1-590; see Figure 1-591; and see Figure 1-592for plug and dowel information supporting pre-1991 model year Series 60 Engines. 1. 5139991 Cup Plug (6 places) 6. 8922327 1/4 in. Pipe Plug (4 places). Torque to 19-24 N·m (14-18 lb·ft). 2. 8929015 Dowel (Round) * 7. 8923312 3/4 in. Pipe Plug (1 place). Torque to 45-56 N·m (31-39 lb·ft). 3. 8929022 Dowel (Diamond) (2 places)* ‡ § 8. 8929152 Dowel (Round) * 4. 8929153 Dowel (Diamond) 9. 8922327 1/4 in. Pipe Plug (4 places). Torque to 19-24 N·m (14-18 lb·ft). 5. 8924140 Draincock 10. 8929594 3/8 in.

Pipe Plug (2 places). Torque to 24-31 N·m (18-23 lb·ft). *Installed to a height of 12.0 mm ± 0.5 mm (0.472 in. ± 0.002 in.). Use tool (J–36244–1)to install. Use tool (J–36244–2) to install. § Refer to illustration for orientation of dowels. Cup plug 7 are installed 2.5-3.0 mm (0.098 -0.118 in.) below the machined surface. Use tool set (J–35653) to install the cup plugs. Coat the outside sealing edge of the cup plugs with a good grade of non-hardening sealant such as Loctite® 620 (or equivalent) before installing. Figure 1-584 Right Side View (Rev. 2005) All information subject to change without notice. 1-664 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION