2.3 N2 ELECTRONIC UNIT INJECTOR Engine combustion is obtained by injecting, under pressure, a small quantity of accurately metered and finely atomized fuel oil into the cylinder. Metering and timing of the fuel is accomplished by the ECM which actuates the solenoid poppet valve to stop the free flow of fuel through the injector. When the solenoid poppet valve closes, fuel is trapped in the injector body and under the plunger. The continuous fuel flow through the injector prevents air pockets in the fuel system and cools those injector parts subjected to high combustion temperatures. NOTE: Do not test new or reliabilt® remanufactured electronic unit injectors prior to installation in the engine.
The Kent-Moore® POP stand should only be used as a diagnostic tool on fuel injectors that have been removed from an engine. Fuel enters the injector through the two fuel inlet filter screens located around the injector body. See Figure 2-3. Filter screens are used at the fuel inlet openings to prevent relatively coarse foreign material from entering the injector. Figure 2-3 Fuel Injector Body NOTE: Effective with September, 1988 production, Series 60 engine EUI nuts incorporate one upper seal ring groove and seal ring, instead of two. See Figure 2-4. (Rev. 2005) All information subject to change without notice. 2-12 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION