2.3 N2 ELECTRONIC UNIT INJECTOR The beginning of injection and metering of the fuel in relation to the crankshaft position are controlled by the ECM. Injection begins soon after the poppet valve is closed. The valve closing point information, known as the response time feedback, is returned to the ECM. This information is used to monitor and adjust injection timing, thus removing injector-to-injector variation influences on timing. The amount of fuel injected depends on the pulse width stored in the calibration which determines how long the poppet valve remains closed; the larger the pulse width the longer the valve is closed and the more fuel is injected.
When the injector rocker arm has completed its downward travel the injector follower spring returns it to the starting position. As the plunger moves up fuel enters the injector pumping cavity for another injection cycle. The constant circulation of fuel through the injector renews the fuel supply in the chamber and aids the cooling of the injector. 2.3.1 Repair or Replacement of N2 Electronic Unit Injector To determine if repair is possible or replacement is necessary perform the following procedure. See Figure 2-5. Figure 2-5 Flowchart for Repair or Replacement of N2 Electronic Unit Injector (Rev. 2005) All information subject to change without notice.
2-14 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION