SERIES 60 SERVICE MANUAL 2.3.2 Removal of N2 Electronic Unit Injector The following steps must be performed prior to removing an injector: NOTE: The solenoid can be replaced without removing the injector. Refer to section 2.3.4. 1. Clean the valve rocker cover around its seat on the head, and in the attaching bolt recesses. [a] To remove the one-piece rocker cover, refer to section 1.6.2. [b] To remove the two-piece rocker cover, refer to section 1.6.3. [c] To remove the three-piece rocker cover, refer to section 1.6.5.
EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. NOTICE: All the fuel must be removed from the cylinder head before removing an injector to prevent the fuel from entering the cylinder and causing hydrostatic lock or washdown. If the head is not thoroughly purged of fuel before an injector is removed, fuel remaining in the fuel manifold will drain into the cylinder filling the piston dome recess. It cannot drain from the dome and, if not removed, can cause hydrostatic lock and bend the connecting rod. 2.
Drain the cylinder head fuel gallery by removing the inlet and outlet lines from the fittings at the rear of the cylinder head. Blow low pressure compressed air into the inlet fitting for 20 to 30 seconds or until all of the fuel is purged from the cylinder head. See Figure 2-6. NOTE: Front and rear rocker shaft assemblies look identical but are not interchangeable because of different bolt hole center distances. The outboard end of each rocker shaft assembly is marked with the DDC logo for identification. Care should be taken to identify and return assemblies to the proper location if both overhead assemblies are removed. NOTE:
Loosening the fuel line at the inlet fitting will allow fuel to flow faster. Carefully collect the drained fuel in an appropriate container. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-15