2.3 N2 ELECTRONIC UNIT INJECTOR Figure 2-6 Cylinder Head Fuel Fitting Locations 3. Remove the two rocker shaft through-bolts and one nut for each rocker shaft assembly, and lift the rocker shaft assembly off the engine. Refer to section 1.3.2. To remove the injector, complete the following steps: NOTICE: Do not remove the screws from the injector. The wire terminals have keyhole slots to fit over the screw head. Turning the screws too far will damage the threads in the injector solenoid housing. 1. Loosen the injector wire terminal screws two full turns and remove the terminal wires. 2. Remove injector hold down clamp. NOTICE:
Extreme care should be used when handling an EUI to avoid costly damage by dropping or otherwise mishandling the EUI. NOTE: When replacing an EUI, always replace the injector O-rings. (Rev. 2005) All information subject to change without notice. 2-16 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION