SERIES 60 SERVICE MANUAL 3. Lift the injector from its seat in the cylinder head by inserting a pry bar under the injector body. See Figure 2-7. Figure 2-7 Removing N2 Electronic Unit Injector NOTICE: Avoid wire brushing the spray holes to prevent damage. 4. Cover the injector hole in the cylinder head to keep out foreign material. Remove carbon from the injector exterior in the area where the tip joins the nut, using wire buffing wheel (J–7944). All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-17