2.3 N2 ELECTRONIC UNIT INJECTOR 2.3.3 Disassembly of Electronic Unit Injector On a Series 60 engine EUI, only the injector solenoid and seal rings are serviceable. The injector must not be disassembled. 2.3.3.1 Inspection of the N2 Electronic Unit Injector To clean and inspect the injector, complete the following steps: NOTE: The injector can be tested either on or off of the engine. EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 1. Clean the exterior of the injector with clean solvent and dry it with compressed air. NOTE:
Do not test new or reliabilt® remanufactured electronic unit injectors prior to installation in the engine. The Kent-Moore® POP stand should only be used as a diagnostic tool on fuel injectors that have been removed from an engine. 2. Test the EUI using J–34760–A. Follow procedures supplied with this tool. Reuse or replace injector or injector and solenoid as indicated by testing. 3. Inspect the O-rings for damage or foreign material. Replace O-rings. 4. Inspect the fuel injector tubes at the injector seat. If required, replace the fuel injector tubes. (Rev. 2005) All information subject to change without notice. 2-18 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION