SERIES 60 SERVICE MANUAL 2.3.4 Repair of N2 Electronic Unit Injector Solenoid and Seals Perform the following steps for solenoid replacement: 1. Loosen the injector wire terminal screws two turns and remove terminal wires. 2. Loosen four hex-head screws and remove old solenoid. See Figure 2-8. 1. Spacer Seals 4. Screw 2. Solenoid 5. Follower Retainer 3. Load Plate 6. Spacer Figure 2-8 Electronic Unit Injector Solenoid Assembly All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-19