Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

2.3 N2 ELECTRONIC UNIT INJECTOR 3. Perform the appropriate step for the DDEC unit used. [a] For DDEC I and DDEC II, discard the solenoid, load plate, follower retainer, and screws. Do not reuse old screws. [b] For DDEC III/IV, discard the solenoid, follower retainer, and screws. Do not reuse old screws. The load plate must be reused. NOTICE: The spacer is a matched component with the armature and must remain with its respective injector. 4. Remove spacer and seals from injector body. 5. Discard seals, but do not discard spacer. 6. Install new seal in spacer groove and position spacer on body with seal facing down. See Figure 2-8. Seal may be retained in groove with small quantity of grease.

7. Install new seal in solenoid groove. 8. Install solenoid on spacer. NOTICE: The load plate on each DDEC III injector is unique and must remain with the injector. The DDEC III load plate carries the injector part number, the injector serial number in bar code format, and the injector calibration code number. 9. Install new screws through the load plate and follower retainer, solenoid, and spacer. (Rev. 2005) All information subject to change without notice. 2-20 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION