SERIES 60 SERVICE MANUAL 10. Thread screws into body and tighten all screws until heads contact retainer and load plate with a slight force (less than 0.6 N·m [5.3 lb·in.] torque) in the sequence shown. See Figure 2-9. Figure 2-9 N2 Electronic Unit Injector Solenoid Torque Sequence 11. Torque screws to 2 N·m (17.7 lb·in.) in the sequence shown. See Figure 2-9. 12. On DDEC II injectors only, etch the last four digits of injector part number on the load plate. See Figure 2-9. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-21