2.3 N2 ELECTRONIC UNIT INJECTOR 2.3.5 Installation of the N2 Electronic Unit Injector Perform the following steps: 1. If the fuel system is contaminated with coolant: [a] Drain the fuel tanks and refill with clean fuel. Refer to section 14.6.2. [b] Replace both filters with new, and clean the fuel/water separator, if equipped. Refer to section 14.6.13. [c] Inspect fuel injectors for damage and replace as required. 2. If the coolant system is contaminated with fuel, flush and reverse flush the system. Refer to section 14.6.4.
EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. NOTICE: Leftover fuel must be removed from the injector bore before injector installation. If fuel is trapped between the top of the injector hole tube and the lower injector O-ring seal, it may seep down to the injector hole tube seal ring, causing swelling and possible seal leakage. 3. Using clean compressed air, blow out any fuel remaining in the injector bore. NOTE: If the engine is equipped with an auxiliary injector tube seal, replace it with a new seal when the injector is removed. (Rev.
2005) All information subject to change without notice. 2-22 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION