SERIES 60 SERVICE MANUAL NOTICE: Do not use a metal dowel as this may damage the seal. NOTICE: Injector seals are considered one-use items and cannot be reused. Any time an injector is removed, all three injector nut O-ring seals must be replaced with new seals. Failure to replace seals can result in seal leakage. 4. Detroit Diesel encourages the use of an additional service seal (5104701) that is impervious to both coolant and fuel. This seal should be used in situations where injector tube seal leakage or deterioration is suspected or confirmed.
Place the auxiliary seal in the injector hole and seat it against the top of the injector tube with a 41.3 mm (1-5/8 in.) diameter wood or plastic dowel. 5. Check to make sure the injector bore is thoroughly clean. 6. Apply a thin coat of clean ethylene glycol to the injector seal rings and install them in the injector nut ring grooves. Make sure seals are properly seated. 7. Insert the injector into its respective injector tube bore. Visually align the injector body for equal clearance between valve springs (there is no locating dowel pin on the underside of the EUI).
After locating the injector, press down on the top of the injector body with the heel of your hand to seat it in the injector tube. NOTE: The injector tube bore should be cleaned and inspected for damage before installation of the electronic unit injector. Refer to section 2.4.4. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-23